![]() ![]() The two hot-shoe mounts allow mounting the LRT PRO Timer to your camera easily in two different angles. You’ll see the firmware which is currently installed during the boot process of the Timer or in the Status-Screen which you can access from the main menu. Don’t worry, the update process as easy as it can be! Check out the Firmware Update Page, there you’ll also find the instructions on how to update. There might be a newer firmware than on the shipped unit. You can update the firmware of your new timer, before you start using it. Clicking shortly on the rotator selects the next value, pressing the button a bit longer (>1/4 sec) goes back to the previous value. To set the date and time, just use the rotator to increase/decrease the number. You’ll see the welcome screen and since the timer has a battery powered real time clock, you will be prompted to set the current date time – you’ll only have to do this once. Just let it charge fully, before you disconnect the charger.Īs always with Li-Ion Batteries: please avoid deep discharge since this could reduce the lifetime of the battery. Then you’ll see a battery charging indication and you can start experimenting with your new timer right away. While charging, however, you can turn on your timer with the small switch on the right side next to the rotator. While the timer is switched off, you won’t see any indication that the timer is charging, this is by design, to avoid any light emitting LED on the timer. You can use any Micro-USB-Charger to charge the battery. Charge the batteryĪfter unboxing your new LRTimelapse PRO Timer please make sure to fully charge the battery. In the following, I will give you a quick overview on how easily get started. ![]() ![]() ![]() Congratulations, you’ve just obtained one of the most advanced intervalometers for timelapse and astro photography! ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |